Rachael Randall
commented over 10 years ago
how much for a pdl brand of upright double power point, i have about ten to change
Gina Joe
commented over 10 years ago
Are you able to replace a themostat on a smeg oven and will the 2 hours cover this?
Ravi Bharathan
commented over 10 years ago
Hi there, I need to install a heater in a couple of bathrooms. How many hours would that take up? Thanks
Jean Gee
commented over 10 years ago
our Asko induction top is blinking fault signals ("0" & "F" alternately)on both hobs on one side only and won't work. The hobs on the RH side ok. Wd you be able to fix, and how many hrs? Thanks.
Joan Garriga
commented over 10 years ago
Hi there,
I have a house with some switches underfloor and inside wardrobes. Would your services include checking those and adding or removing some power outlets?
Also, I need to run some cable to my garden to put a sensor light at the back of the house as well as the far end of the garden. Also in the side of the garage. Would that be included or how much approximately would it cost extra from the voucher?
thank you
Jamie from JMAC Electrical
commented over 10 years ago
Hi Rachel, PDL Trade price for a double powerpoint is $36.40 + GST, Thanks
Jamie from JMAC Electrical
commented over 10 years ago
Hi Gina, If you have the thermostat ready or we know the model and order this prior then 2 hours will be ok, Thanks
Jamie from JMAC Electrical
commented over 10 years ago
Hi Ravi, I would recommend purchasing the 4 hour voucher for best value for installing your bathroom heaters, Thanks
Jamie from JMAC Electrical
commented over 10 years ago
Hi Jean, I would need further information on your hob, Model number & dimensions to answer your question, If you want to email this information to me at bookings@jmac.co.nz I can have a look into this for you on Tuesday.
Jamie from JMAC Electrical
commented over 10 years ago
Hi Joan, The 4 hour voucher is a great deal, I would recommend getting one of these, We can quote the remainder of the work for you however would need to have a look in person to provide you with a quote. Thanks
Pauline Sullivan
commented over 10 years ago
Hi we are wanting two halogen downlights installed in a bathroom and a small heater in a linen cupboard. Would this require more than two hours. Our house is two years old so all existing wiring is good.
Shane Devitt
commented over 10 years ago
Hi there, I'm wanting to put another power point in kitchen, other power points are to far away to loop off, closest power source is the stove mains, which I assume can't be used, how can it be achieved without damaging walls?
Cheers
Shane
Gina Joe
commented over 10 years ago
Thanks for your response. How much is a thermostat for a smeg SA386x-5?
Thomas Fursdon
commented over 10 years ago
Hi folks,
We'll try to get Jamie back online to answer your questions. We should hopefully be hearing from him here shortly :)
Leonie Mercer
commented over 10 years ago
Hi I need a double power point adding to a room that has none, there is a point on the other side of the wall. Plus I have a light bulb broken in a socket. Will two hours be enough for this work?
Thanks Leonie
Julianna Varadi
commented over 10 years ago
HI we have a smeg rangehood one light does not work even changing the bulb so could be the button switch. Also a solid ceramic element simpson hobb and right front element only goes on full. Could these be covered by your offer with parts extra? cheers
Jamie from JMAC Electrical
commented over 10 years ago
Hi Pauline, I would recommend the 4 Hour voucher as the job may take longer, You could always have a list of any other small jobs ready if there is any spare time, Thanks
Jamie from JMAC Electrical
commented over 10 years ago
Hi Shane, Its a bit hard to suggest options without having a look. If you email your details to bookings@jmac.co.nz, We can arrange to come out and have a look at this for you, Thanks
Jamie from JMAC Electrical
commented over 10 years ago
Hi Gina, Please email your details bookings@jmac.co.nz and I will arrange a quote for this on tuesday
Jamie from JMAC Electrical
commented over 10 years ago
Hi Leonie, 2 hours should be ok, Depending on the ease of installing the additional powerpoint. Thanks